Attach to your aero bars

for easy visibility

Automatic Profile Selection

figures out which bike

you’re powering today


Simple to Mount



With any Velocomp power meter there are no special bike wheels, hubs, cranks, or pedals to swap, no sensors to glue to your crank.

And with Newton, you don’t even have to buy and set up a separate bike computer!

Attach your PowerPod or Newton to its mount, pair your device to your ANT+ sensors, then start riding!  After a few minutes of riding your power meter finishes its auto-calibration, and you get accurate power numbers.

After riding use the included Isaac software for Mac/PC to view and analyze your ride, and share your cycling stats on Facebook or Twitter.

For purchasing information click here



All of your critical bike and power stats are clearly shown on the Newton 6 display.  The intuitive, five-button control puts your “Average/Maximum”, “Environment”, “Hill Slope/Wind Speed”, and “Total” stats just a few clicks away.newtonblack_large

Power training mumbo-jumbo and button-punching complexity are scrupulously avoided in the Newton 6.  Along with bike speed and cadence you’ll see current power, average power, maximum power, and calories.  Simple to find, easy to understand.

Only the Newton 6 has the Dynamic Power SmoothingTM display.  With DPS your power numbers are smooth and stable when you’re pedaling at a constant pace, yet jump instantly when you surge.

Watch this short video to see how Dynamic Power Smoothing is superior to old-school power averaging used by the Garmin 810.

And if you want to fine tune or personalize your Newton for maximum performance,  use Isaac software “Set Up Newton” and “Configure Screen” wizards to get the most out of your power.

For purchasing information click here


If you own more than one bike, you can use your PowerPod or Newton on all of them!

Attach a PowerPod or Newton mount and ANT+ sensor to your extra bike, then do a fast, one-time calibration ride.  You’re ready to ride on your other bike!

And Velocomp’s Automatic Profile Selection figures out which bike you’re riding today, then magically configures your power meter for the ride.  Simple!

For purchasing information click here


You don’t have to know the length of your crank arm.

You don’t have worry about which brand of pedals you own.

You don’t have to count the number of spokes on your rear wheel.

You don’t have to glue components to your crank, and you don’t have to hang heavy water jugs off your pedals.

Just decide which Velocomp power meter you want, and where you want to mount it on your bike.

For purchasing information click here